I have a UCS200c sff.. I have 8 600 gb drives two are for ESX-I the remaing 6 are in one datastore .. Capacity shows 3.27 tb available shows 1.27 TB. Is this a bug . It is a 1068 controller , Raid 1 setup for these drives. Help
I tried IM. IME and IS.. I also created a a datastore thru ESX-i and kept expanding. It did the same thing. where I was seeing ot was when you go to the main ESX-i pae, looked at storage and the Datastores.. and it shows capacity and free sizes..
This document will provide screenshots to outline the steps to setup
TACACS+ configuration to ACI and also the configuration required on
Cisco ACS server. Please find the official Cisco guide for configuring
TACACS+ Authentication to ACI:
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...
Cisco Documents are usually accurate, but when it came to the document
on Cisco APIC Signature-Based Transactions it was slightly off the mark.
This document is for those novices to API like me who cant seem to
figure out how to go about performing signat...