Have you tried PSUs on any other slot of the chassis?
Yes. All show 'green' when tried individually.
What happen if you move the green power supplyh to another slot?
If this is the only power supply in use, still stays green.
If I am powering up all 4, then only the first one powered on stays green. The other 3 are amber.
What firmware is the server running:
Not sure. We have not performed ANY configuration whatsoever - no connections to FI, etc. We are only powering up the chassis with all 4 supplies to make sure there are no issues before we delve into connections, etc.
What is the power policy set on the server?
None, as we have not configured anything. Only testing power.
There are some known issues regarding PSUs but we need to have some further information from the device.
This needs to be isolated to determine if there is any hardware failure on the PSUs but I would recommend you to install the server and check firmware version, PSU status and collect show tech support for investigation.
This document will provide screenshots to outline the steps to setup
TACACS+ configuration to ACI and also the configuration required on
Cisco ACS server. Please find the official Cisco guide for configuring
TACACS+ Authentication to ACI:
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...
Cisco Documents are usually accurate, but when it came to the document
on Cisco APIC Signature-Based Transactions it was slightly off the mark.
This document is for those novices to API like me who cant seem to
figure out how to go about performing signat...