Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

UCS Firmware Upgrade from 2.1(1a)

Hello-

I am in the process of planning my Cisco UCS firmware upgrade from 2.1(1a).  Is it recommended that I could directly to 2.1(3a)?  Are there any known issues going directly to this firmware versions?  My environment consists of Cisco UCS 5108 Chassis with B22 and B230 Blades.  I also have multiple UCS C220, C240, and C460 servers along with Fabric Interconnects.  Are there specific steps I should take to minimize downtime and disruptions in my environment?   I have read through the upgrade guides and release notes, but I want to know if anyone else has experienced any issues during their upgrade.

Thank you,

Ben

Everyone's tags (5)
1 REPLY

Re: UCS Firmware Upgrade from 2.1(1a)

Ben,

Just be sure you follow the guide in the sense of what portion of the UCS needs to be activated first.

There is a process of update which does not have an specific order for the different components, but you need to be careful with the activate process, that one has a very specific order so just be sure yuo follow it 100%.

In regards to issues, refer to the release notes not only for the version you will upgrade to but also the nexy one after that one, there might be known issues fixed until the next patch release, however in this case you are planning on upgrading to the latest version available

*** The procedure is made to have minimal disruption and make the upgrade successful, however it is ALWAYS recommended to perform this under a maintenance window.  Waiting for the worse but hoping for the best.   Good luck! ***

-Rate all helpful answers.

-Kenny

Message was edited by: Keny Perez

264
Views
0
Helpful
1
Replies