The FCoE ready SAN (Native FCoE support) seems to be again the future road map.
For the question Lucas asked , as per our discussions with various teams working on UCS we understood that the N5K can also act as a SAN switch if it is kept in NPIV mode. We tested it before we understood this fact with NPV on N5K, it detected the storage box but the N5K was expecting an upstream switch to be NPIV enabled, it was actually referring to the 61xx. We didn’t tested N5K in NPIV mode but as per our discussions it should work as a SAN switch on the NPIV mode.
This document will provide screenshots to outline the steps to setup
TACACS+ configuration to ACI and also the configuration required on
Cisco ACS server. Please find the official Cisco guide for configuring
TACACS+ Authentication to ACI:
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...
Cisco Documents are usually accurate, but when it came to the document
on Cisco APIC Signature-Based Transactions it was slightly off the mark.
This document is for those novices to API like me who cant seem to
figure out how to go about performing signat...