VLAN was deleted in UCSM prior to it being removed as a reference on multiple vNIC's, I'm receiving faults on the vNIC's now in reference to the VLAN that was removed, but its no longer visible on the LAN tab or within the vNIC.
Recreated the issue in a test environment, see below. I should also mention this is part of an updating vNIC template, so I cannot simply expand the VLAN's under the vNIC and delete the VLAN, its greyed out. If I examine the vNIC template and try to modify VLANs to remove, it is not listed.
If I do unbind, delete, and then rebind, it recreates the deleted VLAN that is no longer viewable in the vNIC template.
code="F0933" created="2014-08-29T13:24:49" descr="The named vlan Test for vNIC eth0 cannot be resolved" dn="org-root/ls-JoshTestBlade7/ether-eth0/if-Test/fault-F0933" highestSeverity="warning" id="4419892" lastTransition="2014-08-29T13:24:49" lc="" occur="1" origSeverity="warning" prevSeverity="warning"
This document will provide screenshots to outline the steps to setup
TACACS+ configuration to ACI and also the configuration required on
Cisco ACS server. Please find the official Cisco guide for configuring
TACACS+ Authentication to ACI:
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...
Cisco Documents are usually accurate, but when it came to the document
on Cisco APIC Signature-Based Transactions it was slightly off the mark.
This document is for those novices to API like me who cant seem to
figure out how to go about performing signat...