Is it possible to use UCSE in old SRE environment ?
I had to replace broken SRE module and since it is EOL new UCSE was purchased, however the configuration of it is quite different. Configuration of an interface is well written in installation quide however what about adding UCSE to Central Manager?
In "old" SRE it was like this:
#central-manager address x.x.x.x
1. How to configure this in UCSE?
2. Do I need to use VLAN 1 on Router to enable vWAAS?
Moquery is the command line cousin of Vizore, it's very helpful and efficient sometimes during the troubleshooting. This article aims to provide moquery cheat sheet to the users for some most common seen scenarios.
Here is the checklist before customers/partners contact Cisco TAC:
Firmware Version of APIC and Switch
Download Switch and APIC techsupport logs
Problem description (Symptoms with details)
Business impact (eg, what kind of services...
moquery usageAPIC moquerySwitchmoquery
This document discuss a common issue observed during the VMM integration & VM workload migration to ACI fabric.
VMware Virtual machines are hosted in Cisco UCS-B seri...