02-22-2012 10:54 PM - edited 03-01-2019 10:17 AM
Hi All ,
Could you please help me understand the output of the following command :
ucsm-B(nxos)# sh int br
I have a few queries on the interfaces number eth1/1/1 to eth 1/1/8 :
What governs the naming convetion used for the ethernet ports starting eth1/1/1 to eth1/1/9 ?
If I connect another chassis to the FI , will it start by eth2/1/1 ?
I would like to understand how Eth1/x/x or Eth2/x/x is decided by the UCS for naming ..
--------------- truncated -----------------------------------------------------------------------------------------------------
-------------------------------------------------------------------------------
Interface Vsan Admin Admin Status SFP Oper Oper Port
Mode Trunk Mode Speed Channel
Mode (Gbps)
-------------------------------------------------------------------------------
vfc684 102 F on trunking -- TF auto --
vfc688 102 F on trunking -- TF auto --
--------------------------------------------------------------------------------
Ethernet VLAN Type Mode Status Reason Speed Port
Interface Ch #
--------------------------------------------------------------------------------
Eth1/1/1 1 eth vntag up none 10G(D) --
Eth1/1/2 1 eth vntag up none 10G(D) --
Eth1/1/3 1 eth vntag up none 10G(D) --
Eth1/1/4 1 eth access down Administratively down 10G(D) --
Eth1/1/5 1 eth access down Administratively down 10G(D) --
Eth1/1/6 1 eth access down Administratively down 10G(D) --
Eth1/1/7 1 eth access down Administratively down 10G(D) --
Eth1/1/8 1 eth access down Administratively down 10G(D) --
Eth1/1/9 4044 eth trunk up none 10G(D) --
Solved! Go to Solution.
02-22-2012 11:28 PM
Hello Vikas,
These are host interfaces ( HIF ) / backplane ports on the FEX / IOM connecting to the blades.
Eth
" show fex detail " would provide additional information about FEX ports.
The ninth interface provides CIMC connectivity to the blades,
HTH
Padma
02-22-2012 11:28 PM
Hello Vikas,
These are host interfaces ( HIF ) / backplane ports on the FEX / IOM connecting to the blades.
Eth
" show fex detail " would provide additional information about FEX ports.
The ninth interface provides CIMC connectivity to the blades,
HTH
Padma
02-23-2012 12:07 AM
Thanks Padma for the quick reply ..
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide