Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Upgrading from 2.0 - 2.1, Default Zoning disabled

While planning for an upgrade from 2.0 -> 2.1 we noticed the warning about Default Zoning not being supported in 2.1(1a) and later releases. Is it possible to reconfigure and disable Default Zoning without causing any disruptions?

The system is running on a 6120XP with an 8GB FC expansion module and four connected Storage FC Interfaces. One configured VSAN with Default Zoning enabled.

Everyone's tags (5)
2 REPLIES
New Member

Upgrading from 2.0 - 2.1, Default Zoning disabled

Are there any official guidelines from Cisco released regarding the removal of Default Zoning Support? Any advice is welcome!

Re: Upgrading from 2.0 - 2.1, Default Zoning disabled

Andreas,

In UCSM 2.1 Default Zonning is disabled an cant be used anymore, you need to create the VSAN again and define it manually.

See this thread for more information:

https://supportforums.cisco.com/thread/2185462

Please rate ALL helpful answers.

-Kenny

460
Views
0
Helpful
2
Replies
CreatePlease login to create content