Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

VIP Green

Zoning, direct attached Netapp

UCS V2.2.1b, FC switch mode, Netapp filer direct attached with FC.

SP with 2 vhba, one mapped to fabric A resp.B., 2 FC target end point, one in fabric A, resp. B.

If I check the zoning done by UCS, I actually see 4 zones (SIST) ? why ? I would only expect 2 ??

xyz.png

xyz.png        

xyz.png

Everyone's tags (5)
1 REPLY
Cisco Employee

Re: Zoning, direct attached Netapp

The additional zones get created because of the wwpn targets added in the boot order policy. If you remove or add more targets it will add or remove additional zones

232
Views
0
Helpful
1
Replies
CreatePlease to create content