cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
586
Views
0
Helpful
1
Replies

Zoning, direct attached Netapp

Walter Dey
VIP Alumni
VIP Alumni

UCS V2.2.1b, FC switch mode, Netapp filer direct attached with FC.

SP with 2 vhba, one mapped to fabric A resp.B., 2 FC target end point, one in fabric A, resp. B.

If I check the zoning done by UCS, I actually see 4 zones (SIST) ? why ? I would only expect 2 ??

xyz.png

xyz.png        

xyz.png

1 Reply 1

Manuel Velasco
Cisco Employee
Cisco Employee

The additional zones get created because of the wwpn targets added in the boot order policy. If you remove or add more targets it will add or remove additional zones

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: