About j-shearer

j-shearer · 01-13-2010

The reason for this post is to retrieve some information on how to go about configuring a QoS policy for LWAPP/CAPWAP.Currently, we have a 'hub-and-spoke' topology with one hub location and six spoke sites. Each spoke site has a 100Mbps link through ...

j-shearer · 11-30-2009

Greetings -Currently I have a 2821 is running CME v3.4(0) and has a CUE running v2.0.1 (very old). The IOS currently deployed on the router is version 12.4(4)T1. I have the necessary CompactFlash space for upgrading and I know that I will have to upg...

j-shearer · 10-06-2009

Greetings -I have a WLC4402 currently running software version 4.2.207.0. With 802.11n just getting officially ratified I was wondering what is the "Cisco-recommended" software version for 802.11n? Should I stay at 4.2.207.0 or move up to 5.x/6.x? I ...

j-shearer · 08-05-2009

Greetings -We are running CUCM v6.1 in a single-site topology. We have several "hot spots" where we need to place a wired public access phone (7911G).My plan was to create a separate partition along with separate CSSs for these particular phones. Als...

j-shearer · 06-24-2009

Greetings -I have a CUCM running version 6.1.3.3000-1 and a CUPS server running version 6.0.4.1000-4. I was able to get the IPPM service configured on the CUCM and subscribe the IP phone to the service. I am able to send/receive IMs from the phone. T...

j-shearer · 12-01-2009

Thank you both for the insightful responses. You have both definitely pointed me in the right direction.Joe

j-shearer · 10-06-2009

Thx for the reply.I wanted to stay at version 4.2 if I could. Reason being is that 4.2.x has been very stable and reliable for me while I cannot say I have had the same experience with 5.x. If 4.2.x will support 802.11n then I will continue to use it...

j-shearer · 08-07-2009

Thx for the clarificationI just wanted to make sure that I was going about it the right and that there was not a better or more efficient way of implementing.Thx again.Joe

j-shearer · 07-09-2009

I was wondering if you ever received clarification on this? I have an autonomous 1252 access point that I wanted to configure dynamic VLAN assignment for. I currrently have a WLC configured with MS IAS for dynamic VLAN assignment and everything is wo...

j-shearer · 07-01-2009

That's what I figured. Thx again for your assistance.Joe

Member Since	‎03-31-2004 05:40 AM
Date Last Visited	‎05-04-2023 12:13 AM
Posts	50

User Statistics

User Activity

QoS Policy for LWAPP/CAPWAP

CME v3.4 to v7.x

WLC software version for "N"

Public Access IP Phones

IPPM - No alert for IM message

Re: CME v3.4 to v7.x

Re: WLC software version for "N"

Re: Public Access IP Phones

Re: Dynamic VLAN on Access Point using RADIUS

Re: IPPM - No alert for IM message