About sdross

sdross · 01-22-2004

I have a 1900 switch that has two dsl modem/router connections coming into the switch on fa0/26 and fa0/27. I would like to split the ports so that 1-12 use one connection and 13-24 use the other. The reason is that I need half of the customers to ob...

2900 LRE Configured vs Running Profiles · 01-14-2004

Can someone explain the difference between configured and running profiles and how do I get a port to run the profile that is configured. I have 2 ports configured as a point to point for a company and both ports are configured with LRE-10 profile, h...

sdross · 11-19-2003

I have two 15454s connected with an oc48 connection. an existing circuit was created from an e1000 (far end) card, I assume through the oc48 connection, and then terminates on a e100t card (this end) which can communicate with everything at the momen...

sdross · 11-18-2003

this is on a 3725 router, assume that the 10. addresses are public and the 192 addresses are private.int fa0/0 - internet sideip address 10.1.1.2 255.255.255.252int fa0/1 - lan sideip address 10.1.2.1 255.255.255.224int fa1/0shutint fa1/1shutI have p...

sdross · 11-07-2003

I have a situation were I have many users accessing a gateway to the internet working just fine with "no ip proxy-arp" on the gateway interface. Then I have one user that cannot access the internet unless I allow "ip proxy-arp". Even when this user c...

sdross · 01-15-2004

sh controller lre prof det says Public Profile:N/AWhy might I have one port that still says Running LRE 15-5 and LRE 7. I thought these were Public Profiles and I already disabled them with no lre profile global. Do I need to have the customer restar...

sdross · 01-15-2004

That command wasn't available, but I will try the no lre profile global command. When this is done what happens to the ports? Do the lre's download the private profile from the switch immediately and/or then will the private confirgured profile take ...

sdross · 11-20-2003

Thanks, I will give this a try.

sdross · 11-19-2003

I don't quite understand your response, however if this clarifies a little more here goes. I have public and private addresses inside and I want to nat private inside addresses without using the 10.1.1.2 address on the outside interface. I am getting...

sdross · 10-24-2003

Sorry about that,DC Powercisco 7206VXR (NPE300) processor (revision B) with 229376K/65536K bytes of memory.Processor board ID 15456732R7000 CPU at 262Mhz, Implementation 39, Rev 1.0, 256KB L2, 2048KB L3 Cache6 slot VXR midplane, Version 2.0Last reset...

Member Since	‎05-20-2003 10:06 AM
Date Last Visited	‎08-18-2017 03:50 AM
Posts	59

User Statistics

User Activity

Proper VLAN Configuration for 2 connections

2900 LRE Configured vs Running Profiles

Circuit creation and sdcc termination

Is NAT possible in this situation?

Proxy-Arp Issue

Re: 2900 LRE Configured vs Running Profiles

Re: 2900 LRE Configured vs Running Profiles

Re: Is NAT possible in this situation?

Re: Is NAT possible in this situation?

Re: 7206 VXR Lock Up