Traffic is being redirected but I don't see matches on the route-map. Is there a way to see matches ?   C7606-S#sh route-map route-map AMP_REDIRECT, permit, sequence 1Match clauses:ip address (access-lists): AMP_HTTP_TRAFFIC Set clauses:ip next-hop v...

C7606-S#sh platform hardware acl global-config CM global configurations: Update mode: hitless Default result: deny Match L4 protocols:Real protocol value: 47, encoded value: 9 Reserved QoS Banks:Current 1 banksLatest set 1 banksAfter next reload 1 ba...

C7606-S#sh platform hardware acl global-config CM global configurations: Update mode: hitless Default result: deny Match L4 protocols: Real protocol value: 47, encoded value: 9 Reserved QoS Banks: Current 1 banks Latest set 1 banks After next reload ...

I installed Sup2T engine on 7606-x chassis. I applied ACL and route-map to redirect traffic on an interface. It works fine but ACL and route-map counters not incrementing. Does anyone have the same issue?    route-map AMP_REDIRECT, permit, sequence 2...