Hi,This is driving me bonkers - so much so that I probably can't see the wood for the trees - can anyone shed any light on this please?ASA Version: 8.2(5)33supposed to authenticate toACS Version: 5.1.0.44The ASA AAA config is basic, but it still won'...
HI all,I have a customer with a ESW-540-24 running the versions shown below. Software Version2.1.21Boot Version1.0.0.04The snag I have is that whenever I connect an AP via the power injector, it suspends the port. Using a laptop it...
Hi All,Been handed one I can't work out and would appreciate some some input please. I've been trawling the Cisco docs and got the the IPS 7.1 CLI guide but not the info I need, so I'm a bot snookered.Customer has a pair of ASA5512X with the onboard ...
Hi,Have a customer with ACS 3.2 which will be upgraded to 4.2.Having no experience of 4.2, can you guys please tell me if there is a way to import the AAA clients without too much drama?From looking at the other posts, I guess that CSUtils is the ans...
Hi,Seen the docs that state the 4710 appliance uses neither PAGP nor LACP.The snag I have now is that I have a 4710 connected to 2 x 3750X with one port in each. The switch ports must be LACP but the output of show etherchannel summary is:2 Po2(...
Hi Guys,The client has decided to just stick with local creds while they troubleshoot something else that has cropped up.I've had no feedback from your suggestions though, as the decision was out of my hands.Thanks again for your input though guys, m...
Jatin/Peter,Thanks very much for your input.I'll go and tweak the required AAA bits (as we were trying different things yesterday) and get back to you.Thanks againAli
Hi Colin,I have a similar issue.No doubt you've read the world's supply of documentation as well, but I still can't resolve this. My issue is not quite the same but very similar. It's not quite the same as there are different interfaces that have bee...
Hi Tom,Thanks for the reply.Yeah tried that too but when you first log in to the switch and click Smartport Wizard, the new window opens OK but does not allow me to select a port I tried hovering over the port on the switch image that appears, selec...
