About ben.tan

ben.tan · 11-24-2011

Hi,Not sure why the N7K M1 card doesn't take this command. It works on other N7K at different site. Anybody seen this before??BNZ-AKDCM2-L01-DC-01(config)# hardware access-list resource pooling module 9ERROR: Resource-pooling is not supported with ce...

ben.tan · 11-04-2011

Hi,Anybody seen the issue below yet? I am on NX-OS 5.2.1. The Mod is M1 card. The FEX port (Nexus 2248) end up in err-disabled after TCAM exhauseted. I have to remove "QoS" policy on that port and bounce the port. Than it will come back up again. 201...

ben.tan · 07-19-2011

Hi,I have 2 x 3750X stack together. The question is do I need to power down the devices before adding the stack power cable?Ben

ben.tan · 06-26-2011

Hi,I have a WS-C2960G-48TC-L switch and would like to replace the faulty RPS. The question is, do I have to power down the switch first?Thanks.Ben

ben.tan · 11-24-2011

Hi,No, I am not running WCCP. Here is the solution by using the "hardware access-list resouce pooling" command. ##Enable TCAM resoruce sharing##hardware access-list resource pooling module 9hardware access-list resource pooling module 10## Reload th...

Member Since	‎06-26-2011 08:42 PM
Date Last Visited	‎08-18-2017 03:53 AM
Posts	5

User Statistics

User Activity

"hardware access-list resource pooling" command not working

Tcam resource exhausted on Nexus 7010 M1 card

3750X with stack power cable

2960 switch with RPS-2300

Tcam resource exhausted on Nexus 7010 M1 card