I have a pix 515 that was running IOS 6.3 and I just upgraded it to the 7.24 IOS. I followed the steps from the Cisco web and during step 2. where you send the .bin file to flash, I get a "host not found" error. I have done everything I can to get it...

Hi,The Security Natzis have asked if i can hide or disable the user from seeing the network configuration page of the phone. I would still need to let the support people have access to it. If anyone has herd of this please let me know.

Hello all,I have a basic setup question. I am a newbe when it comes to this part of CCM configs. I am setting up a single CCM and Unity system that will service 4 remote sites connected by WAN. Each site will have its own PSTN GW configured in CMMy g...

HelloI am using CM 4.1 and a VG-200 with a 2FXO-M1 and a 2FXSI have H323 configured on the 2FXO-M1 so I can use the caller-Id feature.The CM has a route pattern of 9.@ for out bound calls. Under MGCP control, all outbound and inbound calls works ok. ...

I have CM 4.2 I would like to know if there is any way to get call manager to see a MC3810 so it's FXO's and FXS's can be configured for MGCP. The MC3810 is not in the list of gateways that can be configured.