About ciscotech45

ciscotech45 · 03-09-2014

In an ASA active/standby pair setup that I have, an upstream router seems to be getting ARP requests from both the active and standby ASA. Is that normal? I thought only the active unit would do all the ARP requests and ARP tables get replicated to t...

ciscotech45 · 01-29-2014

Hi, I am used the older 8.0.X ASA software, so here's another confusion I have with the new 9.1x code. I unfortunately don't have an ASA 9.1x handy to try out these commands.1. Here below is two different ways of creating the same service object as I...

ciscotech45 · 01-27-2014

I have a question on how the NAT0 (nat bypass) statements would look like for an ASA 9.1x code. I am now running 8.0.2. Here is how the relevant parts of the config looks like: (certain information have been modified)interface GigabitEthernet0/0no n...

ciscotech45 · 01-09-2014

Hi,I have a few questions on the new 5500-X series ASAs.1. We are planning on using two of these in an active/standby HA pair. Now to manage these, I understand I will need the Prime Security Manager (PRSM). Is this management utility only available ...

ciscotech45 · 03-09-2014

thanks for clearing that up.

ciscotech45 · 02-15-2014

thanks. So when I assign an IP to the management interface to manage the CX, do I have to specify an IP for the standby ASA's management interface as well? I have the ASAs in an active/standby config now.Also, how is the CX module's status evaluated ...

ciscotech45 · 02-13-2014

Okay great. Thanks yet again.I am normally not in the habit of using the management interfaces of the ASA. But if I understand this right, for managing CX (via ssh, https) I can only use the management interface IP and not any other interface IP, cor...

ciscotech45 · 02-13-2014

okay, I finally have the ASA X and have set it up using just the CLI and ASDM without even touching the CX module. All's well But now, I want to check out the CX module, a few questions in that regard:1. How do I begin accessing the CX module initial...

ciscotech45 · 01-30-2014

thanks very much for explanation and actually testing it out!I also have a similar question regarding the network object group.Which of these (option-A or option-B) would be a better way of doing it in the 9.1x code? And like in the case the service ...

Member Since	‎09-25-2006 02:35 PM
Date Last Visited	‎08-18-2017 03:53 AM
Posts	15

User Statistics

User Activity

ASA standby unit ARP request

ASA 9.1x Object Groups

ASA 9.1X - NAT0

Cisco ASA 5500-X Series Next-Generation Firewalls

thanks for clearing that up.

Cisco ASA 5500-X Series Next-Generation Firewalls

Cisco ASA 5500-X Series Next-Generation Firewalls

Cisco ASA 5500-X Series Next-Generation Firewalls

ASA 9.1x Object Groups