caymil
Level 1
Level 1
Member since ‎11-12-2002
‎08-18-2017

User Statistics

  • 9 Posts
  • 0 Solutions
  • 0 Helpful votes Given
  • 5 Helpful votes Received
Recent Badges
1 Helpful Vote

User Activity

Was wondering if anyone else experienced this issue:Currently have a WLC4402 installed with 21 AP's reporting to it. The controller is running at LWAPP3 with version 3.2.116.21. The WLC was purchased prior to Cisco buying Air-e-space, and has a 36 AP...
Just curious, as the documentation for the WLC 4402 states "Note The Utility Port (1000 Mbps Ethernet, RJ-45) is not currently used and is reserved for future use.".It would be great if CISCO could notify WLC customers about when and/how this port ca...
Does anyone know of any AP models that are ISAFE, and will work with the WLC 4402?Thanks,Chris
I have a WLC 4402 that I am using in a wireless testbed. During the initial configuration, I followed the basic configuration guidelines for the L3 LWAPP. Tried to configure the Service-port without an IP(0.0.0.0), but it would not accept it(msg."Ser...
Hi, I am setting up a WLC2006 with 2 AP1010's. I cannot get the controller to see either AP. When I place the AP's on a network with a WLC 4400, they are recogized immediately by the 4400 at Layer-2 LWAPP. Since the WLC2006 only works at Layer-3 LWAP...
Community Statistics
Member Since ‎11-12-2002 08:23 AM
Date Last Visited ‎08-18-2017 03:50 AM
Posts 9
Total Helpful Votes Received 5
Helpful Votes From