About sanamon

sanamon · 10-12-2008

Lately we've started getting this alarm om some of the controllers (we have 18 controllers). Does anyone have any more information on what the severity of this is, an how to troubleshoot?The WCS help text for this alarm is "This indicates that a high...

sanamon · 10-18-2008

ours are running 4.2.62.0

sanamon · 10-16-2008

In that case you might want to turn short preamble back on again as this increases throughput...Regards,Jonas

sanamon · 10-15-2008

Are You sure the old cards support 128bit WEP? Some cards only supported 48/64 Bit WEP (such as the Orinoco silver cards etc)From the config I can see that long preambles are now configured.

sanamon · 10-14-2008

I would put both in there for failover.However this DNS record is only used for APs that doesn't have a primary controller configured (normally the first time its powered on)

sanamon · 10-14-2008

It might be that Your old cards dont support short preamble.Try disabling short preamble for the 802.11b radio from the GUI or from the CLI:Step 1 configure terminalStep 2 interface dot11radio 0Step 3 no preamble-shortStep 4 end Step 5 copy running-c...

Member Since	‎01-08-2007 03:41 PM
Date Last Visited	‎08-18-2017 03:53 AM
Posts	10

User Statistics

User Activity

CPU Receive Multicast Queue is full on Controller

Re: CPU Receive Multicast Queue is full on Controller

Re: Aironet 1240AG unable to connect to 802.11b cards

Re: Aironet 1240AG unable to connect to 802.11b cards

Re: cisco-lwapp-controller where to point?

Re: Aironet 1240AG unable to connect to 802.11b cards