About dburgess.adliteuk

dburgess.adliteuk · 08-26-2011

HelloI'm hoping someone can offer some good advice to this problem I'm having. We have a cisco 2800 router and are now required to allow users to be able to connect to another company's extranet. Having tried this it wont allow this connection so I h...

dburgess.adliteuk · 12-29-2010

Hi hope somenone can help me on this. I am trying to change a static nat entry from thisip nat inside source list 1 interface Dialer0 overloadip nat inside source static tcp 192.168.0.246 25 interface Dialer0 25ip nat inside source static tcp 192.168...

dburgess.adliteuk · 09-29-2010

We have a Cisco 2800 router that we are having problems getting e-mail messages through that are are above 4MB. Emails are fine coming in and I have checked the exchange 2003 settings and the report is that the connection was dropped by the remote ho...

dburgess.adliteuk · 09-01-2011

Thanks for your reply Edison its much appreciated I am attaching the full config file as I had chopped it down. If you get chance to have a look I would like to hear your opinion on the full config. Or if You can advise me how to troubleshoot where t...

dburgess.adliteuk · 12-30-2010

My next option is to configure access on the wan interface. I will need to look into how to do this as I have inherited this cisco router and although I have some experience with cisco routers I am by no means an expert. I have no physical access to ...

dburgess.adliteuk · 12-30-2010

Hi Thanks everyone for your interest and advice it is very much appreciated. The do clear ip nat trans still had the message static entry in use when I use the no ip nat inside source. I think I will have to configure the remote access on to the wan ...

dburgess.adliteuk · 12-29-2010

Hi Todd thanks for the prompt response. ip address 192.168.0.254 255.255.255.0 no ip redirects no ip unreachables no ip proxy-arp ip nat inside ip virtual-reassembly zone-member security in-zone ip route-cache flow duplex auto speed auto no mop enabl...

dburgess.adliteuk · 09-29-2010

Hi chiorean,Thanks for your help. I did reply but have found it didnt make its way to the forum. The value was set to 20000000 so this doesnt seem tom be the problem but I do think you're on the right track with the reset can you tell me how i switch...

Member Since	‎09-29-2010 02:53 AM
Date Last Visited	‎08-18-2017 03:54 AM
Posts	9

User Statistics

User Activity

Allowing vpn connection out to extranet

clear ip nat translation (static)

Remote connection dropped by host

Re: Allowing vpn connection out to extranet

Re: clear ip nat translation (static)

Re: clear ip nat translation (static)

Re: clear ip nat translation (static)

Re: Remote connection dropped by host