Hi All,I have 6xxx switches are connected back-to-back across a trunk link with 2 sets of ports channeled together to form the trunk.To solve one of my problems, I needs to make a permanent CAM entry on one of the switches that associates a MAC add...
Hi all,Can anybody tell me when I add static route to my default network it shows with Administrative distance of 1,whereas we know that static routes to our own interface have AD. of zero.ExampleC 10.77.152.128/25 is directly connected, FastE...
Hi ,Can anybody tell some good links not only on cisco site but any where about T1 and E1 concepts all including CCS and CAS.I would be very thankful for the same.Regards,Munit
Hi ,There default ports given in the IOS .We can use both to refer those ports by names as well as port numbers .Can we customize it and to the defaut list ports by names not by numbers. or I want to use it use customized ports used for my applicatio...
Hi when ever i try to ping my routers(client side) serial interface I am unable to do .after debugging I came to know how ping to our own interface is working.Whenever we are pinging our own interface the ICMP request goes to the other end of serial ...
Hi ,I have local aaa defined and tested on 12.3(4)T1 on 72xx router, It works fine.I am able to allocate address to the IOS Vpn client from the local pool defined on the VPN serverSee the debugs:===========Jan 17 15:43:28.838: ISAKMP (0:134217804): ...
Hi Ken,Transport mode is only negotiated between two hosts not between two subnets.Here Permit ip any any indicates between two lan subnets any traffic should be encrypted.Please check the o/p show crypto ipsec sa, and check whether what Mode is nego...
Hi,Actually My source and destination vlan machiens are in different vlans and that too on different switches so I dont know when I give the set cam per 00-00-fa-bc-dc-cc 1/1 which vlan it will bind too or it will map to the Default Vlan that is mana...
See Although for E1 connection we require external CSU/DSU when we go for back to back no need here.......I have cheacked the full configuration it works.Just tried cross cable it worked.No other cable worked I went according to pin specification ,ma...