velo84
Level 1
Level 1
Member since ‎04-27-2005
‎01-28-2021

User Statistics

  • 55 Posts
  • 0 Solutions
  • 25 Helpful votes Given
  • 25 Helpful votes Received

User Activity

If you have a pair of 3750 switches in a stack. You then split the stack (not from a config point of view, just say for e.g switch two is powered off) Switch one stays powered on and functioning as the master. If a number of config changes are then m...
I have Telegraf setup and monitoring interfaces on Cisco routers correctly. Is it possible to monitor IP SLA instances with this same setup? If anybody has had any luck with this I would be grateful if you could share the setup. Thanks 
I'm currently redistributing OSPF to BGP and setting a local pref on the routes. Currently this works fine and having no issues.  ip prefix-list ospf-routes seq 10 permit 172.16.100.0/24 route-map ospf-bgp permit 10 match ip address prefix-list ...
I have two of the same routes in my routing table, one is OSPF and one is eBGP. I want the OSPF route to be preferred over the BGP route. (The eBGP route will be the backup route when the OSPF route is gone)I configured a BGP route map to apply a hig...
I have two Nexus 9000s configured as VPC. I have an ASA firewall with a VPC port-channel to the Nexus switches. I am peering OSPF between the Nexus and the ASA. Both of the Nexus and the ASA are in Area 0. I want to block some routes being installed ...
Community Statistics
Member Since ‎04-27-2005 12:31 AM
Date Last Visited ‎01-28-2021 07:09 AM
Posts 55
Total Helpful Votes Received 25