About slunney

slunney · 09-23-2009

Our 5510 switched to the standby unit 2 weeks ago, and since then, I have not been able to get the primary back online. The configs are identical line for line however when the primary is put back into service, dns requests from the internl servers a...

slunney · 09-30-2004

Using a PIX 515eI have multiple webservers in the DMZ the first web server and the mail server are set up with the port mapping to the PIX outside interface IP address.The second and third(on the inside interface) webservers are set up with static m...

slunney · 09-29-2009

I unpatched and repatched every connection, and shut it all down again and this time it worked when it all came back up. I would have liked to have figured out the cause in case it happens again, but it's working now, so i'm moving on. Thanks guys.

slunney · 09-23-2009

I have actually done that already, with a packet capture inbound and outbound. I looked at them in Wireshark and the only difference between the working Standby traffic and the non-working Primary traffic is that the dns queries never get a response ...

slunney · 10-01-2004

I did a clear xlate, I also did a cold boot a couple of times.I can attach to the servers port mapped to 207.236.60.34but not 207.236.60.35 or 207.236.60.35

slunney · 09-30-2004

Here are the relevent sections of the configuration.global (outside) 1 interfaceglobal (outside) 2 207.236.60.39global (inside) 1 interfaceglobal (DMZ) 1 interfaceglobal (DMZ) 2 192.168.10.39nat (inside) 2 National 255.255.255.0 0 0nat (inside) 2 Reg...

Member Since	‎07-20-2004 07:29 AM
Date Last Visited	‎08-18-2017 03:54 AM
Posts	7

User Statistics

User Activity

ASA5510 Active/Standby Primary won't allow dns response

second Webserver on DMZ not visible outside

Re: ASA5510 Active/Standby Primary won't allow dns response

Re: ASA5510 Active/Standby Primary won't allow dns response

Re: second Webserver on DMZ not visible outside

Re: second Webserver on DMZ not visible outside