When setting up my second Thunderbolt device I would get continual flashing diag light. I tried a factory reset to no avail (reset button for ten seconds) I turned the device off and plugged the supplied USB drive into a PC and it could not be read. ...
First of all I think this will become a great product. After using it for a couple of hours here is my two cents.Topology view.Right now it only discovered the subnet with the Access point and ESW switch on it. It failed to identify my Uc520 and it...
After upgrading a UC520 to 8.0 using CCA2.2 my 7975 phones display an Auth Failed message and do not upgrade firmware.I'm wondering if it is a problem with the signature on the firmware image or a UC520/CCA configuration issue.
There is now a 3rd party iPhone Sip client that works successfully with the UC500. It does have the Apple imposed limitations on Use over 3G and not being able to run as a background process on the iphone, but other than that it works pretty well.Fo...
Try This . . . Navigate to ---> H323 Profile [1..1] CallSetup ModeThe H.323 Call Setup Mode defines whether to use a Gatekeeper or Direct calling whenestablishing H323 calls.NOTE: Direct H.323 calls can be made even though the H.323 Call Setup Mode i...
VCS to CUCM is supported through a SIP Trunk. Cisco has published a design guide for this.http://thetpsite.com/forum/topics/cisco-unified-communications has a link.
