About deepali.shinde

deepali.shinde · 09-22-2011

Dear Experts,We upgraded our Call Manager ( MCS7835H2 ) publisher and subscriber from version 7.1.1 to 7.1.5 , after which we configured 7911 for extension mobility and we try to login to the phone , get the error " No services Configured" . The 7911...

deepali.shinde · 09-15-2011

Dear Experts,We have ASA 5520 configured for failover and it was working fine. When we wanted to reload the firewall and inactive( Primary) to become Active , we saw that it is in Failed state. The DMZ2 interface in the capture below is the logical s...

deepali.shinde · 01-10-2011

Hello Experts,I require your help. We have VIC-4FXO on Cisco 2811 , where the analog lines are terminated. The router is configured for H.323. The caller-id was working fine and since yesterday we are not getting caller-id.I enabled debug vpm signal ...

deepali.shinde · 11-01-2010

Hi Experts,We have a customer who wants to have static mapping of two public IPs to one internal IP .These public IPs will use the same service i.e httpEg: 83.X.X.1 to 10.10.10.1 83.X.X.20 to 10.10.10.1Please let me know if this is possible on...

deepali.shinde · 04-14-2009

We have the branch and Head Office connected through MPLS. On thr branch router we have the LAN connected to inside of ASA and outside interface terminates the MPLS link. We have the same security levels on both outside and inside interface. We have...

deepali.shinde · 10-04-2011

The issue was resolved by Cisco TAC. The issue was with the switch port , though IP Phone was coming up fine, the port had CRC and input errors. After changing to a different port , Extension mobility is working fine.Sharing the link, which the TAC e...

deepali.shinde · 09-23-2011

Thanks Shalu. I have followed all the steps that has been mentioned and still see that the services are not enabled on the phone.Still continue to get the error "No services configured" .If I login to the 7911 phone that was configured for extension ...

deepali.shinde · 09-15-2011

Thanks! Varun. The issue is resolved. You were right! the switch did not have the DMZ2 L2 VLAN on it and after adding it,its working fine now.

deepali.shinde · 09-15-2011

Thanks Varun. Pasted the output of sh failover of Inactive FW.I am unable to ping DMZ2 10.40.56.130 , this is logical interface , its one of the sub-interface created , the other sub-interfaces DMZ1 and DMZ3 are up and in Normal state.hostname# sh ...

deepali.shinde · 01-10-2011

The issue has been resolved after removing the analog lines and putting them back to the voice ports followed by a reload.ThanksD

Member Since	‎05-05-2008 03:48 AM
Date Last Visited	‎08-18-2017 03:54 AM
Posts	24

User Statistics

User Activity

Cisco CCM upgrade from 7.1.1 to 7.1.5 causing extension mobility issue

ASA Failover not happening

Caller-id not getting displayed,but debug shows caller-id received

Static mapping of two Public IPs to one internal IP?

OSPF not populating routes on ASA

Cisco CCM upgrade from 7.1.1 to 7.1.5 causing extension mobility

Cisco CCM upgrade from 7.1.1 to 7.1.5 causing extension mobility

ASA Failover not happening

ASA Failover not happening

Re: Caller-id not getting displayed,but debug shows caller-id re