About Hanif Saharudin

Hanif Saharudin · 05-20-2017

Dear Experts, We have installed Cisco ISR(ISR_1 and ISR_2) and Cisco FW(FW_1 & FW_2) as per photo below. I already perform PERMITALL to each FW. So no blocking issue in FW. We perform test FW_1 to FW_2 (using cross cable)without ISR, all the VLAN ab...

Hanif Saharudin · 05-15-2017

Hi Experts, We have installed 1 unit 2504 WLC and 3 unit RAP. All RAP configured with the same configuration and tested before a All RAP configured and done tested, all joined WLC. After a year, I power up the WLC and RAP once installed at site, on...

Hanif Saharudin · 04-10-2017

Dear Cisco Experts, I have got a problem to control the rules/traffic at the inside Firewall device. I have 2 unit workstation which the IP is PC-A is 10.1.0.101, 255.225.0.0 and PC-B are 10.1.1.125, 255.255.0.0. This two PC is located inside port ...

Hanif Saharudin · 03-26-2017

Dear Cisco Expert, I unable to perform static routing inside ASA interface. If I perform command "ip routing" on my L3 Switch, I've trouble to control the L3 switch InterVLAN. (I don't want VLAN 100(OLEO) and VLAN 101(ESTER) talk each other, Only VL...

Hanif Saharudin · 09-26-2016

Hi Expert, I have a problem to join AP1523E to WLC2504. I already configure the WLC and put the MAC filtering list of AP's. For the Switch, I already configured port for WLC is "switch port mode trunk" and for RAP switch port as "switchport mode ac...

Hanif Saharudin · 05-19-2017

Dear Scott, Thanks for your email. I already perform as per you said. But it still not able to join WLC. If AP connected to switch, we still able to see the MAC address even its not join right? I perform command ''show ip arp'' in my WLC and in switc...

Hanif Saharudin · 05-16-2017

Dear Scott, Thanks for your response. I already perform the MAC Filter at the WLC. Another 2 RAP is joined, but this one RAP not joined. Really need to update the v8.2? because another joined RAP use same V8.0 also and no problem to join. Really no...

Hanif Saharudin · 05-16-2017

Hi Leo, Thanks for your response. We already set the static IP. We use IP 10.51.14.13 for this AP. WLC use 10.51.14.11. Is it that true configured right? interface BVI1 mac-address 381c.1a22.5be0 ip address 10.51.14.13 255.255.255.0 Thanks and be...

Hanif Saharudin · 04-12-2017

Dear Jon, Thanks for the links. I'll go through this documents and try to perform filter at L3 within VLAN. Will update later if successful. Thanks for your time. Regards, Hanif

Hanif Saharudin · 04-11-2017

Dear Jon, Thanks for your comments. Now used L3 switch, 3750 series. Can configure something at L3 switch to block the RDP service? Thanks, Hanif Saharudin

Member Since	‎09-21-2016 11:31 PM
Date Last Visited	‎10-09-2019 06:50 PM
Posts	24

User Statistics

User Activity

VLAN not able reach after applied ISR device

AIR-CAP1552SD-C-K9 could not discover WLC

How to control network traffic using ASA if IP in same subnet segment

static route ASA 5506-x firewall to L3 Switch

AP1532E not join WLC2504

Dear Scott,

Dear Scott,

Hi Leo,

Dear Jon,

Dear Jon,