About marcsauve0

marcsauve0 · 07-14-2010

Hello everyoneI'm trying to configure mwi for GDM and am not having much success. I tried a couple of different ways suggested in a discussion here:https://supportforums.cisco.com/message/3091135?tstart=0 but don't think I,m doing this the right way....

marcsauve0 · 06-23-2010

Hello everyoneI finally got my SIP trunk provider. They have their side configured but I can't place or recieve any calls. I keep getting a busy signal both ways. I tried dialing 9 then a local number and I keep getting a busy signal.I have a cisc...

marcsauve0 · 04-12-2010

HelloI'm looking for information on how to install 2 newly purchased cards and keep running into dead links. The cards I bought are for a CISCO-2801-CCME/K9 with PVDM2-8, FL-CCME-25, SP Services 128F/256D cisco router:vic3 2fxs/DID and a vic2 2fxo...

marcsauve0 · 07-14-2010

Thanks very much for the help Rob. This command does indeed take care of having my GDMlight up but now if I try to send a message to the main phone line x1001 and leave a message it only has the enveloppe now and doesn't light up...lolIt is a great c...

marcsauve0 · 07-14-2010

Ok...I configured the same as above including a new mailbox for the x1008 in CUE, a user in CUE and indeed can see the enveloppe on all phones but still no mwi light on any of the phones. I believe the easiest way would be to create a shared line on...

marcsauve0 · 06-30-2010

Finally got it working.Problem 1: No inbound calls. Service provider issue. Missing a command.Problem 2: No outbound calls. Service provider issue. Missing 2 commands.. At least the problem wasn't on my side. All is great now.Thanks for the help

marcsauve0 · 06-25-2010

I can now receive incoming calls but cannot place any outbound calls.I called the service provider and got them to check their end and they had to remove the username and password since I have a static IP. The problem now is outbound calls. I still k...

marcsauve0 · 06-24-2010

Hello BrandonThanks for the help. I tried that and still no go. No changes. I think my problem may be with the phone not registering with the SIP server.Unless the phone registers with SIP I don't think I can place or receive any calls (not sure sinc...

Member Since	‎04-12-2010 05:24 AM
Date Last Visited	‎08-18-2017 03:54 AM
Posts	12

User Statistics

User Activity

how to configure mwi for GDM (general delivery mailbox)

sip trunk configuration problems with cme

How to install 2-port vic3 2fxs/DID and 2-port vic2 fxo on cisco 2801 router

Re: how to configure mwi for GDM (general delivery mailbox)

Re: how to configure mwi for GDM (general delivery mailbox)

Re: sip trunk configuration problems with cme

Re: sip trunk configuration problems with cme

Re: sip trunk configuration problems with cme