Hi guys,Is a L2TPv3 through WAN right way to setup redundant connecion between 2 locations of datacenter ?Primary connecion is ethernet vlan trunk. All vlans are present on both locations.Regards, Marko
Just found the root cause:We have an HA pair, and the actual config file for the connection profile was missing on secondary device, so when it was put to active mode during upgrading process, apparently config pointing to missing file was removed. ...
I had the exact same issue!Windows event viewer was reporting most useful information, which wasn't available in debugging webvpn anyconnect: NETENVIRONMENT_ERROR_PROBE_INCOMPLETE:Network Probe could not contact target
Function: ConnectMgr::getProfil...
Hello to all,I had pretty much the same problem, where there was no ringback on outbound calls.The setup was:local PBX<==ISDN E1 ===> CISCO GW (28xx) <==SIP==> VoIP ProviderOn a gateway, i recieverd 183 Session in progress upon outbuond INVITE from p...
Hello giuslar !Thank you for fast response.Yes, I know that there can be too much of L2 traffic, and this concerns me most, because routers are not dedicated to this tunnel.I'll just have to make some tests.What about packet fragmentation ? Should I ...
