Anyone has configured successfully 3G/HSPA using Cisco 1841 HWIC-3G-HSPA to NTT Docomo network.There is no username/password required.APN: mopera.flat.foma.ne.jpBelow is my partial config. My cellular interface keeps reset between UP and Down status....

The switch drop to rommon mode with the following errors:Failed to get configurationInvalid parameter block -- no mac address available.Xmodem file system is available.switch: flash_initInitializing Flash......no flash filesystems found.switch: dirLi...

I have a Guest/DMZ WLC terminating EoIP tunnel. After the user is authenticated by Web Auth, only HTTP/HTTPS traffic is required to redirect to Bluecoat Proxy for filtering.The Bluecoat Proxy and DMZ WLC wireless guest users are located in different ...

I have a 2811 with the following:- HWIC-4ESW + ILPM-4 - 2811 power supply with black IP Phone icon (Inline power support)- IOS 2800 adv ent 124-22TI cannot issue "show power" command and my HWIC with the inline daughter card installed does not supply...

Anchor WLC redundancy is achieved through the mobility groups. For redundancy, we can increase the mobility group size, including additional controllers for redundancy.Does N+1 redundancy works across different mobility groups (Anchor WLCs in differe...