I am using a 3560 Switch with two routed interfaces, I am trying to add a new HSRP instance, but am getting the following error message. % More than 32 standby groups not supported in this platform.I understand there is a limitation on these switc...

I have a problem when i try to apply a policy map to a routing interface on a Cisco3560I have firstly defined the access-list and the route-map. But the problem occurs when trying to apply the ip policy to the physical interface.ip access-list exten...

HiI am looking some help with an issue we presently have with our 6509's Just wondering whether anyone else had the same problems... We have a WS-X6148A-GE-TX and WS-X6348-RJ45 card installed in different switches. Both are installed in slot 4 but ...