About 5sdrexel

5sdrexel · 10-24-2002

Hello everyone, I have 2 Cisco's that I can not get the serial ports to come up. One is a 2610 with a Wic-1T interface and the other is a 1751 with a Wic-1T interface. This circuit has been working fine with the 3-com routers hooked up. As soon I plu...

5sdrexel · 10-28-2002

Both ends are "up and down". The loopback I performed was with a patch cable plugged into the loopback connector on the power cable of the Adtran and the other end went into the network jack of the TSU. Not sure how else to do it. All the lights are ...

5sdrexel · 10-28-2002

Thanks for everyone's input. The encaps is HDLC on both ends. I've done a ton of these and have never had any issues before. The funny thing is that it works with the 3Com's, therefore, I know the circuits and the TSU are good. I have looped the CSU ...

5sdrexel · 10-24-2002

I says it's just an Adtran TSU...Kinda like the 100 but not. I'm wondering if it's a timing thing that the 3Coms do differently than Cisco.Thanks for any help.......

5sdrexel · 10-23-2002

Wouldn't the bridge-group command on the second interface be "bridge-group 1" instead of 2 ? That is just my understanding of how bridge groups work.

Member Since	‎03-05-2001 02:42 PM
Date Last Visited	‎08-18-2017 03:50 AM
Posts	6

User Statistics

User Activity

Adtran TSU configuration

Re: Adtran TSU configuration

Re: Adtran TSU configuration

Re: Adtran TSU configuration

Re: 1600 Setup as bridge