About 5avelsberg

5avelsberg · 02-10-2012

Hi,I have a 1142N which does not join the WLC when connected via a 2960 switch. When I connect a different lap 1142N to the same port on the same switch using the same cables, it does join the lap to the WLC. And when I connect the first lap directly...

5avelsberg · 02-16-2012

Option 43 did the trick.Note: You must use the management interface of the WLAN controller.Complete these steps in order to configure DHCP Option 43 for lightweight Cisco Aironet access points in the embedded Cisco IOS DHCP server:Enter configuration...

5avelsberg · 02-14-2012

It is recommended by Cisco, according to the manual, to separate those two (ap-manager and management)

5avelsberg · 02-14-2012

Thx all for your assistance so far,I have 2 working AP's connected to my 2960 switches. The third AP does not want to join when connected to the 2960. Even when I disconnect the other 2, it still doesn't want to join. It only joins when connected dir...

5avelsberg · 02-14-2012

Have to check, but i want to keep ap-manager en management separated. Keep in mind that the AP works fine when connected directly to the WLC

5avelsberg · 02-14-2012

Added option 43 to the dhcp scope, RegardsJeroen

Member Since	‎02-07-2012 07:04 AM
Date Last Visited	‎08-18-2017 03:54 AM
Posts	7

User Statistics

User Activity

lap 1142N not joining WLC2106

lap 1142N not joining WLC2106

Re: lap 1142N not joining WLC2106

Re: lap 1142N not joining WLC2106

Re: lap 1142N not joining WLC2106

Re: lap 1142N not joining WLC2106