About cbradleyspp

cbradleyspp · 10-12-2005

I am unable to create a DMZ on my 831 SDM router. I go through the advancend firewall setup. The page shows the select DMZ interface to use but it is grayed out. I have my server directly connected to interface fa2. Any help is greatly appreciated,Ca...

cbradleyspp · 09-28-2005

My switch was working fine until around 7-8 PM MST on Sept 27. Ports 1-16 are flashing green and amber a very fast rate. Checked console and here is what I'am seeing:error intializing transceiver ports%PLATFORM_CAT2950-3-SCHAN_OP_FAILURE: S-channel o...

cbradleyspp · 09-13-2005

On my 831 FA1 has my uplink from my 2950. My FTP server has multiple NIC's for load balance in my office. One NIC is assinged to my FTP service which works great. Heres where I'm stuck at. Before switching to my 831 I had a basic Linksys where I coul...

cbradleyspp · 09-12-2005

I have had to delete my IOS from flash due to it being corrupted. I have tried to go in and download the new IOS, but with no luck. I have set all required varibles for ROMMON and I get the error: "Missing or illegal ip address for varieble IP_ADDRES...

cbradleyspp · 09-04-2005

I need help with setting up my cisco 831 sdm k9 router. It was up running just fine but I ran the write-erase command to start over, little did I know that resting back to complete factory defaults did not work. The router did not go back to as if it...

cbradleyspp · 10-12-2005

Upgraged to the 12.4.1 and its still showing grayed out.

cbradleyspp · 09-20-2005

I don't have any proxy setup at all. I was able to configure the router to passthrough ftp traffic to go out and works fine but I still can't get ftp traffic to come in. It is configured to passthrough ftp traffic to the ip for my server but still no...

cbradleyspp · 09-14-2005

Found the issue with not able to ping my server but accessing it. Thats fixed but the original issue is still at hand.My IOS: 12.1.(13)EA1Current configuration : 2751 bytes!version 12.1no service padservice timestamps debug uptimeservice timestamps l...

cbradleyspp · 09-14-2005

Just did so more troubleshooting and here is the odd thing. I can't ping any of my systems but the switch & router.I can access the internet and shares on my pc's and network drives on my server but cannot ping at all to it. I can not FTP to my serve...

cbradleyspp · 09-13-2005

Thank you very much Shanky. I got SDM installed and and now resetting to factory defaults then I'll configure the router. Thank you very much for the help.

Member Since	‎09-04-2005 05:55 PM
Date Last Visited	‎08-18-2017 03:54 AM
Posts	19

User Statistics

User Activity

Create DMZ on 831

Need HELP 2950 Erroring out.

Configuring SDM on 831 to allow FTP traffic

Installing flash with ROMMON

Unable to reset 831 router back to default settings

Re: Create DMZ on 831

Re: Configuring SDM on 831 to allow FTP traffic

Re: 2950 Acting Strange

Re: 2950 Acting Strange

Re: Installing flash with ROMMON