hi.We have an MPLS link between cityA & cityBBGP is configured to advertise the connected network on both the routers.I can see the routes(LAN IP Block) of CityA on CityB router but on cityA router there is only one BGP route which is of the WAN IP, ...

hiwe have a requirement where in we need to run GRE tunnel over a frame-relay point-to-point to link i need questions to the following.1.Can we configure GRE tunnel over a Frame-relay point-to-point link2.What is the minimum router requirement3.Sampl...

We have a IPSec Tunnel built between 2 PiX Firewalls, (Pix 506E & Pix515E) we are trying to put e-mail traffic on this tunnel, it is between two microsoft exchange Servers. though the latency between the Firewalls is less then 250 mili seconds. mail ...

We have a IPSec Tunnel built between 2 PiX Firewalls, (Pix 506E & Pix515E) we are trying to put e-mail traffic on this tunnel, it is between two microsoft exchange Servers. though the latency between the Firewalls is less then 250 mili seconds. mail ...

hiWe presently have 4 E1 Links in a Multilink Bundle with EIGRP running between the 2 routers, these links have unequal costs (latency) We are facing the following problem.1.Whenever one of the links continiously flaps in a Bundle EIGRP Neigbour dies...