Hi,Is it possible to configure an asa 5510 as an inline transparent firewall and use it also as an VPN gateway?How does the config looks like?RegardsJorg

Hi All,When we connect a new supervisor IV to our Catalyst 4507R (IOS) the led shows green. But via console cable it stays in ROMMON Mode. When we connected earlier the supervisor to an other chassis to place a new ios on it (IOS cat4000-i5s-mz.122-...

HiWe're planning to upgrade our network infrastructure to this design.R1 is connected to r2 and R3R4 is connected to R2 and R4 (wen applying this post the connection between R2 and R4 is not displayed correctly)R1 ---- R2 | | | |R3 ---- R4...

Hi All,We are going to setup a new core network. Is it necessary to enable udld on the gigabit ports? Isn't spanning tree taking over when the gig port is going down.We tried to simulate this, we enabled on 3 routers spanntree and connected each of...

Hi,I notice in our organisation an access list which is allowing tcp and udp ports greater than 1.Why are ports (TCP and UDP) 0 and 1 used for. As I was reading on the internet i noticed that tcp port 1 is used for service multiplexing.So when 2 hos...