Dear All,I have a VWIC2-2MFT-T1/E1 card which is connected to a Siemens PBX using 2 E1 controllers (using Q-SIG). I also have enough PVDM2 modules to accomodate 60 voice channels.I want to utilize both controllers on this card to get 60 voice channe...

Dear All,Would having 550 BGP routes on an 1841 router (256MB memory), have an impact on the traffic performance. The WAN link is an ethernet access with 256K B.W.Regards,Mouhannad El Hajj-Mahmoud

Hi Everyone,I am using a VPN setup between two sites. And would like to understand the relation between 'bits/sec' and 'packets/sec'. Basically i have two sites running an IPSEC between them, (crypto map is configured on the WAN interfaces. So as an ...

I have a router connected to my PBX using a VWIC, which only supports 30 channels. i require to support around 100 channels, as most of the other branches are dialing to the HO. Is there some way to bind more than 1 VWIC to increase support for the n...

I have a 2691 Router with a VWIC-1MFT module being used to connent to my Siemens HiCom PBX, (running QSIG). Right now this can support a maximum of 30 channels between my router and the PBX. To add to this i am using VOIP-(extra info). However if i r...