I am having an issue getting this router configured properly. It is a VERY basic setup for our end-users. WAN is DHCP and LAN is DHCP. I am getting address from ISP and my PC's are getting addresses from the router. I can PING outside (google, e...
I cannot ping from the router to the Internet with IP ROUTING enabled and no route.Building configuration...Current configuration : 3730 bytes!! Last configuration change at 20:02:18 UTC Thu Feb 6 2014 by radmin! NVRAM config last updated at 20:02:19...
OK no luck on changing the IP to next hopI was able to retrieve the next hop by disabling the IP ROUTE though as suggested by jon. This is very bizarre.I will try the option Jon provided by removing the route and enabling the IP ROUTE option again.
My ISP only provides dynamic addresses. My next hop could change as well for all I know. I could try it temporarily but I am not sure this is a stable solution.
ip source-route goneThe trace route from the client to the WAN IP was successfulTraceroute to the 4.2.2.1 was not. It went as far at 10.10.10.1 (Vlan 1)I have tried ethernet connection and AP to the ports. Neither has been successful.I know it must...
