Hi,ISP has delivered the MPLS link on the MUX, Now we i am going to extented the cable from mux to cisco Router with the serial interface with RJ48 connector.Please let me know which cable should i use to extend the link Striaght or C...
I have a 1130 cisco access point,we are using this for wireless cisco IP phone connectivity to the network.Earlier access point was woring fine and we were able to make calls through IP phone.But we have relocated to new place.Now the access point is...
I have two swithes with me sw1 and sw2 and i would like to configure portchannel on these to swithces for trunk connectivity.SW1(1/48)po1<--------------->po2(1/48)SW2SW(12/48)po1<--------------->po2(2/48)SW2My question is that,If i configure SW1 to p...
Hi leo,i amsure that switch has enough POE power but the issue is that the switch is not providind the power more than 7.3 as you have mentioned.ASB-BAN-SW58>sh modChassis Type : WS-C4507RPower consumed by backplane : 40 WattsMod Ports Card Type ...
Excellent answer Peter!!!!But one more question form your answer,did you say me that the MPLS is shared link but in our office we have dedicated MPLS link in pur office..Am i messing up something?
Nik,Please find the output below.i believe the secondary sup is faulty.OFS-MUM-SW14>sh redundancyRedundant System Information :------------------------------ Available system uptime = 1 day, 3 hours, 9 minutesSwitchovers system experienced = 0...