I need to remove a configured 3750g out of a 7 unit stack. I want to replace it with another unit that is the same. How to keep the config correct an get the unit into the stack.
Thank you Aaron. That is what I needed to know. The switch is defective and I want to keep the config of the stack. It is in a productive state and I did not want to disrupt the network for an extended time.Thanks again.
I guess I didn't make it clear. I want the new switch to take on the config of the switch I remove from the stack. If I remove a switch the config is still in the config of the stack and the switch still shows as a member of the stack. I want to remo...
