gjcluttrell
Level 1
Level 1
Member since ‎03-05-2005
‎08-18-2017

User Statistics

  • 16 Posts
  • 0 Solutions
  • 0 Helpful votes Given
  • 0 Helpful votes Received
Recent Badges
10 Replies
5 Replies

User Activity

Current set up is:1 - 4402 - 50ap WLAN Controller with code 4.2.130.01 - 2125- 25ap WLAN controller with code 5.2.15735 - AP1010 access points17 - 1100 series access pointsI've told each access point which controller is its primary controller but aft...
I have a Cisco AIR-AP1131AG-A-K9 wireless access point. This AP is an autonomous (stand alone) AP not used with a wireless controller. I used Cisco's upgrade tool & the correct image to upgrade the AP to LWAPP (so it could be used with a Cisco wirele...
Hello,I have 2 cisco 3550 switches. I have 2 vlans, VLAn1 & VLAN3. I have 3 ports on vlan 3 & all others on vlan 1. I need to grant access to 2 ports that currently are on vlan1 access to vlan 3. In essence, I need to know the CLI commands to grant 3...
Can I configure an ACL on a Cisco 3550 Catalyst switch? If so, is there anything special I need to configure on the switch other than the ACL?
I have a problem & I can't figure it out to save my life!!! I have a Cisco 3550 switch with 1 VLAN. The VLAN is named VLAN 1 with ports 0/10, 0/11, 0/12. 0/13 in it. I have an ISA server on port 0/2. Any of the computers that are in VLAN 1 (in the po...
Community Statistics
Member Since ‎03-05-2005 05:26 PM
Date Last Visited ‎08-18-2017 03:54 AM
Posts 16