About christew

christew · 08-27-2009

I have the following configuration.router (2821 with nm esw016) - trunk (single cable) - switch (3550)I configured the router to be vtp master and switch to be client.I need to be able to telnet into both the switch and the router from a client plugg...

christew · 08-26-2009

I'm trying to use the track command to determine if a route is present or not via eigrp. If the route is not present then I would like HSRP to fail over to the standby router.I'm tracking a route to a loopback across a WAN interface. The tracking w...

christew · 08-13-2009

I have two 2821 with the NM-ESW16 modules. I have the two NM-ESW16 in a trunk configuration. Now I need to have a vlan that that is configured on the router to attach to the router gi0/1 interface. Normally this would not be an issues since I woul...

christew · 08-27-2009

Boy do I feel dumb right about now. I guess in my configuration I forgot to configure ssh on the router, so of course ssh would not work when I tried to connect.Everything is working just fine, just not enough mountain dews or maybe too many.Thanks

christew · 08-27-2009

Yes the client is in vlan 2. I have attached the configurations.

christew · 08-27-2009

I can now login to the switch from the client; however when I try to connect to the router at 192.168.3.1 (router) I get connection refused. If I try from the switch to the router no problem.If I try from the router to switch I get connection refuse...

christew · 08-26-2009

Disregard got it to work. It was an HSRP configuration.

christew · 08-26-2009

Here are the config's.

Member Since	‎05-18-2009 10:11 AM
Date Last Visited	‎08-18-2017 03:54 AM
Posts	13

User Statistics

User Activity

Trunk Ports

HSRP and tracking ip route

VLAN

Re: Trunk Ports

Re: Trunk Ports

Re: Trunk Ports

Re: HSRP and tracking ip route

Re: HSRP and tracking ip route