Hi, Someone seen this before?The Serial interface not showing at all and any command relating to it reporting a "invalid command" error? Say like when you try a Router(Config)#int S0/0 Thanks

Hi guys, I have this 2950G switch that I have cascaded by use of several methods;Fiber, a cross-over cable on the ethernet ports and still behaves strange.What happens is that after irregular intervals of 5 minutes 30 Minutes or even a whole 8 hours...

I'm cascading two 2950 Switches using a GBIC module on each of the switches.However one of the devices reports the error:-ETHCNTR-3-LOOP_BACK_DETECTED:, keepalive packet Loop-back detected on GigabitEthernet0/1 . The portis forced to link down.I have...

Hi, I've got 2 Cisco Secure PIXes 506.Question is with these am I set to implement a PIX to PIX VPN and what software version do I need on the devices? How about the hardware specs,say like memory?Thanks.

I have a PIX 501 whose password I want to reset.Problem is I follow the TAC authored steps to achieve this and somehow my connection to the server where the Password file resides is not succeeding.Question is how do I go about preparations for my TF...