Attached is a diagram showing the current network configuration.Currently the UC500 Wan port (192.168.0.250) is connected to the Dlink ADSL router. we have set up a static route on the DSL router to 10.1.1.0 using 192.168.0.250 as a gateway.We're ha...
Hi All,I have UC500 with 4 FXO PSTN port lines (Australia) , is it possible to change the CLI so no matter what trunk is used the main number will go out as a CLI?thanks.
Hi All,System UC520I can call the the analogue extension the cordless phone is on but i can NOT Transfer to it. Is there anything i should enable to allow transfer to analogue port?below is the running config for that port.voice-port 0/0/2 cptone AU ...
Hi ,I have a customer with two sites.The main site will have the UC500 ... in the remote site they are having two IP handsets, which is easy enough.At the remote site the customer has two PSTN lines.Can we use an ATA with FXO or a small gateway to co...
Hi all,I set up a blast group, once the call is answered on one of the extensions, the other handsets are showing the call as a missed call.could someone please help to reslove the above.thanks.
David, i did added those rules. didn't work either.see attached debug file.Dave, i removed those files. i will email you tonight or tomorrow.cheers thanks
Hi all,i tried #rule 1 /\(.+\)/ /0\1/ same problem see debug file.i have attached the running config, could you please check maybe there is a rule that is actually omiting the last digit which i am not aware off.001528: //-1/FED57BB98148/RXRULE/regxr...
Hey David, how are you doing mate?i tried the 10 dots before it didn't work either. because if you look at line 000463 for some reason when i am dialing the missed call it is changing the number to 043317797 instead of 0433177970. => don't know why...