I am working a new firewall project that requires policy based routing to route all port 80 and 443 traffic to the load balancer which the filters are connected too. Our Cisco router is unable to do PBR because of IOS version. We have a Linux confi...
What required sup module, memory and ios version is needed to run policy-based routing on a 7603. Anyone expert input is greatly appreciated. Thanks, Tou
I cannot figure out why outside access cannot get to our web server via HTTPS. We have PIX 520 running 6.2. When I do a port scan for 443 it does not show it open even if I configure the ACL for HTTPS access. Thanks for the assistance.
I currently running old code of: 12.2(17d)SXB11a. Besides checking the CPU load, what is another way to check to see PBR is working correctly?ACL:ip access-list extended smoothwall deny ip host 10.189.100.2 any- content filters in the vlan configu...
Jon,Sorry for the confusion. Based on my configuration that I posted, I could not get it to work so I assume that the 7603 did not support it. All along it may have been me mis-configuring it. I will take your advice and apply it to correct interf...
Not drawn in the topology, the WAN link is a port channel interface with 3-1 gig interface. Do i apply that to the port channel config. Also, what about the traffic that is from the local network and not drawn in the topology is the traffic from th...
Peter,Thanks for the fast response and very good explanation. I greatly appreciate your time in helping me solve this issue. I am currently running an old 7603 with old code but there lots of policy maps for QoS so I am not sure why my PBR does no...
Thanks Patrick,You are always with very fast at responding with correct answers. I am sure I am not the only that appreciate your kind assistance. I am going to attempt the solution later today. Thanks,Tou