About mattkaya56

mattkaya56 · 02-23-2009

How can I deny access to specific websites using acl on a router with NAT with overload enabled? DNS and name server are enabled.Currently I have interface FastEthernet0/1 description connected to Internet ip address 192.168.1.80 255.255.255.0 no ip ...

mattkaya56 · 04-11-2006

HelloHelp with 2948G _ I am unable to ping the gateway. VTP has no entries in config. the config is as followsThanks in AdvanceMatt#version 8.3(2)GLX upload ! !#frame distribution methodset port channel all distribution mac both!#ipset inter...

mattkaya56 · 04-05-2006

HelpHow can I enable dot1x multiple-authentication on 2948G. The image is 8.2(GLX).Thanks in AdvanceMatt

mattkaya56 · 09-02-2009

The mode you are looking for is multi-auth. Not all switches support - the higher end switches do. I remember it was supported on 3750build 12.2(50) S.E and later.http://www.cisco.com/en/US/docs/switches/lan/catalyst3750/software/release/12.2_50_se/c...

mattkaya56 · 05-06-2009

Hello Dan,If you know the mac address of the NIC on the host. Try show mac-address-table address - it should display or show mac-address-table interfaceThanksMat

mattkaya56 · 04-28-2009

I think this is because credentials are cached. To test the theory 1) Wait for a while arbitrary interval say > 10 minutes and retry. It should fail if you try to use the old credentials.2) Reboot switch. Retry it should not allow.

mattkaya56 · 04-01-2009

Can you post the configuration please.When you say client do you mean PC or radius client? I have seen this error when you use Windows client.

mattkaya56 · 03-21-2009

All what you mentioned are required. You should be able to telnet based on ip address on the switch/router belonging to any vlan - assuming we have routing between vlans either via a one arm router or an L3 switch.Here is a sample config.ip dhcp excl...

Member Since	‎04-05-2006 03:50 PM
Date Last Visited	‎08-18-2017 03:55 AM
Posts	40
Total Helpful Votes Received	10

User Statistics

User Activity

ACL with NAT question

How to overcome port blocking

How to enable dot1x multiple-authentication

Re: 802.1x Multi-Host Mode

Re: How to tell if anything is connected to a switch port

Re: dot1x , Cisco ACS and AD problem in password changes

Re: 802.1x Problem

Re: Telnet