kirti_bapat
Level 1
Level 1
Member since ‎04-22-2006
‎08-18-2017

User Statistics

  • 16 Posts
  • 0 Solutions
  • 0 Helpful votes Given
  • 0 Helpful votes Received
Recent Badges
5 Replies

User Activity

hi all,can someone please tell me the use of pix command authorization set on acs. i understand the use of shell command authorization. i am sorry if the question is too silly. i am completely new to this area.thanks in advance.regardskirti.
hi all,i need some help in configuring downloadable acls on asa.i have configured a downloadable acl on the asa as follows - permit tcp host 2.1.1.2 host 1.1.1.2 eq 80. i get authenticated successfully , but i get an error saying acl authorizaion den...
hi all,i am configuring cut-thru proxy on asa.the config guide says that the authorization acl should be a subset of the acl used for authentication.in my scenario i am using telnet to auhenticate the user and i want to authorize traffic from 2.1.1.2...
Hi All,my scenario is as shown below :R1>>ASA1>>internet>>ASA2>>R2i have established the ipsec tunnel between the two ASA's. now, when i run ospf on both these ASA's ,they do not become neighbors. as per the cisco doc ASA allows OSPF unicast to work ...
i need some help in configuring the idsm2. I have configured the 6509 switch to capture network traffic using SPAN. i have mentioned vlan as source, for the source SPAN traffic. but after specifying the capture destination on the 6509 (a physical por...
Community Statistics
Member Since ‎04-22-2006 11:23 PM
Date Last Visited ‎08-18-2017 03:55 AM
Posts 16