Could someone explain the various link-failover mechanisms and how they work in this particular design?Cisco describes this approach, "The time-proven topology that provides the highest availability does not require STP/RSTP convergence. In this topo...
I've got a standard pair of Cat 6500s w/ HSRP in my core, running OSPF. We're about to connect to a satellite campus over a routed connection (running over DWDM). The topology is a pretty basic collapsed core design with our closet switches running...
I'm running 12.3(8) JEA3 on a Cisco AIR-AP1220-IOS-UPGRD (PowerPC405GP) processor with 15138K/1236K bytes of memory.Any way to broadcast more than 1 SSID?AP-CIS1200 -(config-ssid)#guest-mode Dot11Radio0: Guest-ssid already existing on ssid XXXX⢠Su...
I just wondering if anyone had a suggestion as to how best setup a load-balancing environment in DR. Here's a quick rundown.I've got two 11503's, that load-balance numerous servers here internally. Using a 0ne-arm configuration. Would like an acti...
I noticed that under downloads on CCO, the top of the list is 8.10, further down is 8.20. Should I use WebNS 8.10? 8.10 and 8.20 have the same release dates. Any gotchas out there?
OK, I'm almost there, but I'm a little confused about VLAN 10. It exists on both ds1 and ds2 (and as1), correct? What about SVIs for HSRP? Do I use SVIs for the real interfaces on the VLAN and a standby IP? What IPs do I use for the L3 interconne...
OK, I see what you're saying, but can you go into more detail about how as1 forwards over both links at the same time with HSRP in the mix? The Cisco ARCH guide says that this works with HSRP or w/ GLBP.How do the HSRP hellos get sent? ds1 -> as1 -...
Makes sense to me now. You have solved my problem. Thank you so much.So, basically I need to look at it from the perspective of the switch rather than the traffic-flow perspective. So, how do I award you points?