I have a 2620 running C2600-IS-M 12.3(5) that I'm trying to setup a Multilink Bundle using 3 T1's on PowerQUICC Serial interfaces.When the T1's are connected the sh int command displays:Serial0/1:0 is reset, line protocol is upAdvice?
Correct. Right now the T1's are plugged into the working router so the site isn't down.Here is the output of sh inv and sh ver as the router is on the other side of the country:XXX-XXX-XXX-XXX#sh invNAME: "", DESCR: "2620 chassis, Hw Serial#: 307246...
Right now the controllers are set to 'T1'. Most of this config was not done by me, but I get the mess to clean up.Here is the out put of show controller t1 0/0, 0/1 and 0/2 (The three that will be in use):T1 0/1 is down. Applique type is Channelize...
I tested all the interfaces with a known working T1 supplied by AT&T, yet they never change.Right now with no T1's plugged into the router I'm getting the same status, but with line protocol down. But once I plug in even a known good the reset statu...