william2u
Level 1
Level 1
Member since ‎08-08-2005
‎08-18-2017

User Statistics

  • 96 Posts
  • 0 Solutions
  • 8 Helpful votes Given
  • 5 Helpful votes Received
Recent Badges
1 Helpful Vote
20 Replies
10 Replies
5 Replies

User Activity

Q1: Port that host are linked must become access link, configure them with the best practice so that the ports will directly go forwarding at startup.Answer 1 : Switchport mode access Switchport access vlan x Switchport portfastAnswer 2 : sw...
Frame Relay rate limiting : ·Maximum throughput is 128kbps·During congestion, your provider will mark any traffic in excess of 48kbps as discard eligible,Make sure your throughput changes accordingly, based upon BECNsreceived, only.·Your token buc...
(Web cache system)+ (User) --- (e0/1)R1(e0/0)---(Internet)R1:Ip wccp web-cache Int e0/0 Ip wccp web-cache redirect out * my question is , do i need any command for e0/1 ? since the web cahce system + user is ther ?* do i miss anythings ?
Hi Gurus,My Reflexive Access Lists is not woking, do you have any idea on it ? am i did the wrong config ?* i juz wan my telnet session reflect in the ACL. ip access-list extended OUTR2 permit tcp any any eq telnet reflect test deny ip any anyip acce...
Hi guru, i got question here :RA ---- RB(EIGRP 10)QUESTION :RA do not inform any topology change over the RB ANSWER: 1. RA configure passive interface2. ? (Other than passive interface, stub? )Thanks in adavance for advices.
Community Statistics
Member Since ‎08-08-2005 11:37 AM
Date Last Visited ‎08-18-2017 03:55 AM
Posts 96
Total Helpful Votes Received 5
Helpful Votes From
Helpful Votes Given To