About smcarthur

smcarthur · 09-09-2003

I have just upgraded some 2621 routers to IOS 12.2.16a and have noticed that the interfaces are always UP. This causes routing problems. Show Int fa0/0 says "keepalive not set". When I set keepalve manually it tells me that 10sec is the default. If ...

smcarthur · 12-28-2005

You could configure the NAM as a Netflow collector and configure other routers and some switches to send Netflow data.Scott

smcarthur · 11-05-2005

Netflow uses flows. This usually requires data from switching cache which means that it comes in one interface and leaves via another. You may have traffic which PS sees but which is not actually switched through router and does not appear in netflow...

smcarthur · 11-05-2005

Have you tried exporting the data from a Loopback address? This has the advantage of data still being sent even if an interface may be down (alternate routing being available).

smcarthur · 07-08-2005

Zaldy,You should have the two buildings on seperate lans, have the routers join these two lans using the wireless connection. The dhcp servers are on this local lan and then you do not need IP helper, unless you plan to use the other building dhcp se...

smcarthur · 06-23-2005

FEIP cards only supported one full duplex port or two half duplex ports (speeds were onl 100). When you configure two ports at FULL DUPLEXX you start to get problems.FEIP2 cards support FULL DUPLEX on both Ports.Scott

Member Since	‎06-19-2003 04:55 PM
Date Last Visited	‎08-18-2017 03:50 AM
Posts	8

User Statistics

User Activity

2600 Fastethernet keepalive not set

Re: NAM2 IP Conversion

Re: PacketShaper and Netflow.

Re: Netflow Export Problem

Re: Routing and switching problem

Re: CRC errors between 2924 and 7000